021-57648032
联系电话:
当前位置:首页 > 新闻资讯 > 技术资料
Skylink斯凯力3寸不锈钢特氟龙隔膜泵 SK80/3XAA/NTTT/0B0 隔膜泵安装注意事项
来源:上海邦泉泵业 发布时间:2021-04-21 点击:

3寸不锈钢特氟龙隔膜泵SK80/3XAA/NTTT/0B0

进气接口:3/4"(BSPT)

泵壳材质:316

隔膜材质:Teflon

球阀材质:Teflon

最大流量:988L/min

最大出口压力:8.6Bar

Skylink 斯凯力气动隔膜泵SK80 3寸泵性能参数 

Skylink斯凯力气动隔膜泵,选型咨询报价,详情咨询上海邦泉泵业,021-57648032。

 

SKYLINK AODD pumps are able to fulfill different requirements of most demanding fluid transfer, they are designed as well as manufactured in such high quality, in order to satisfy our clients’ various demands. SKYLINK provides diaphragms which are made of different elastomeric materials to be suitable for different environments according to clients ‘requirements.

斯凯力气动隔膜泵高超的设计和制造品质,能够满足客户不同需求以及苛刻条件的流体输送。斯凯力可根据客户的要求提供不同弹性材料制成的隔膜,以适用于不同的环境。

 

Piping管道:

The pipes which are connected to the inlet and outlet must be incompressible material, so that those pipes are able to bear a high vacuum. All piping should be equivalent size or larger than the diameter of the inlet and outlet, which will improve pump’s performance.

连接到入口和出口的管道必须是不可压缩的材料,以便那些管道能够承受高真空。所有管道的尺寸应大于或等于进口和出口的直径,这将提高泵的性能。

 

Installation安装:

Engineer and installation personnel shall propose an integrated installation plan, which will make pumps perform better, meet fluid transfer requirement and easier to maintain in the future.工程师和安装人员应提供一体化的安装计划,以满足流体输送要求,而且将来更方便维护。

 

Location位置:

When install pumps, enough space shall be left for maintenance personnel to do maintenance or even rebuild your system, such as add a pressure gauge or a valve on the pump in the future. 安装泵时,维修人员应留有足够的空间进行维修或重建系统,如将来在泵上加装压力表或阀门。

 

Air supply供气:

Each pump must have a sufficient air supply to meet pump’s air demand, if air supply is not powerful enough, the pump will not reach its best performance. Use air pressure up to 8.6 bar (125Psig) according to different pumps.In addition, proper air filter and regulator are also important for pump to its p erformance, so SKYLINK recommends that a 5μ(micron)air filter shall be applied before pump’s air inlet.

每台泵都必须有足够的空气供应以满足泵的空气需求。如果空气供应不足,泵将无法达到最佳性能。根据不同的泵,使用空气压力最高可达8.6巴(125Psig)。此外,适当的空气过滤调压阀对于泵的性能也是重要的,因此斯凯力建议泵进气口前应使用5μm(微米)空气过滤器。

 

Solenoid control电磁阀控制

If air supply of pump is controlled by solenoid valve, a three-way valve shall be applied in order to release the air which is stuck between the pump and valve.

如果用电磁阀控制泵的供气,则应采用三通阀,以释放泵和阀之间的空气。

相关产品
版权所有© 上海邦泉泵业制造有限公司. 沪ICP备13011057号-2  沪公网安备 31011702006190号
销售中心:上海市洋河浜路68号 销售热线:021-57648032,021-57648031   管道循环泵  螺杆泵  管道泵
公司网站:www.shbqmp.com 销售邮箱:shbqmp@163.com 图文传真:021-57648031
 
上海邦泉泵业移动端网站         上海邦泉泵业微信号